Striking, polished stainless steel, the Lewmar V-Series windlasses utilize a reliable worm drive gearbox, and accept rope-chain or all chain rodes.
A particular feature of the V1 - V3 Series is its incorporation of the FastFit clamping system in which the windlass shaft self-aligns to the motor orientation during the installation process. This eliminates the need for trial and error shim fitting, and makes installation much faster and easier.

Suitable for most boats from 27 to 50 ft in length; see Spec Table for details
Sleek, low profile, windlasses for power or sailboats keeps foredeck clean
For rope, chain, or combination rodes (3-strand or 8-plait rope required)
Automatic rope/chain transition
Power up/power down, with manual free-fall feature
Hassle-free lower unit alignment and installation with the "FastFit" clamp system (allows incremental positioning of the motor within the alotted range)
Cone clutches provide large braking surface for precise control when lowering in free-fall mode
Manual recovery system is available as a separate option
Pre-fitted with switch and magnet for chain counter applications
Standard 12 volts, 24 volts is available
Typical deck thickness is 1" to 2-1/4", supplement with a suitable backing plate, if necessary; an optional extended version is available for thicker decks
Note that G4, G40, G43, and High Test (HT) chains are equivalent for sizing purposes
3-year warranty

What's in the box windlass, mounting studs and base gasket, up/down rocker switch, dual-direction solenoid, and circuit breaker

Is one of these windlasses a good choice for your boat? You can use the recommended typical boat lengths provided or, for a more rigorous determination, take the total weight of your ground tackle (anchor + rode) and multiply by 4. The maximum pull capability of the windlass should be at least as large as the resulting number.